1. Welcome to the new VFR Forum. Please be sure to read the "Welcome to the new forum" thread in General Spouting. This contains some important information. I hope you enjoy the new site. Steve (The Gremlin) Just so you are aware the new URL for this site is: vfr.bikersoracle.com
    Dismiss Notice

PCV Map VFR800 VTEC 02

Discussion in 'Performance Upgrades' started by chris.mogs, Aug 26, 2017.

  1. chris.mogs

    chris.mogs Mogs

    Hi all,
    Ive just got hold of a PCV fron eblag and Im looking for a base map, the units second hand and set up for micron pipes. My bikes fitted with the full Delkevik exhaust (Sounds amazing) and K&N filter.
    I look forward to your advice:)

    Regards
    Chris
     
  2. Egg on Leggs

    Egg on Leggs Registered User

    PC tend to come with a zero map. I would suggest that, in my experience, the map that is on it will be close enough until you get a custom map.
    I had my VTEC set up for K&N and Remus cans. Since that was done I removed all the unnecessary plumbing without noticing a difference, I then fitted a Motad and ran it for a few months before getting it dyno'ed. This did make a difference to the smoothness and fuel consumption.
     
  3. joemcd

    joemcd Well-Known Member Club Sponsor

  4. chris.mogs

    chris.mogs Mogs

    Many thanks
     
  5. joemcd

    joemcd Well-Known Member Club Sponsor

  6. moonster

    moonster Well-Known Member Club Sponsor

    PCv with custom map for my Leo Vinci cans on mine .... Very good . Very smooth
     

Share This Page